Carlton 1712 Operator's Manual download pdf (Page 70)

12” CHIPPER MACHINE OPERATION

SHUT DOWN PROCEDURES

• With engine RPM still high, push the

feed control bar to the middle (off)

position. Feed wheels should not be

turning.

• Push the throttle down into the low

position so that the engine can slow

down (idle) and the clutch can be

disengaged.

• Once the engine has had time to slow

down below 1200 RPM, disengage the

clutch by pulling back on the clutch

engagement handle. NEVER ENGAGE

OR DISENGAGE THE CLUTCH AT

ENGINE SPEEDS OVER 1200 RPM.

CAUTION: Chipper disk will continue to

spin even though it is disengaged!

• Allow the engine to idle for 5 minutes.

This allows the engine to cool.

• When the clutch has been fully

disengaged and the engine has had time

to cool down, you can turn the ignition

key to the off position.

• Allow the cutter disk and belts to come

to a complete stop, which will take

several minutes.

• Remove the ignition key.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 164 165

No comments

Carlton 1712 Operator's Manual Page 70