Carlton 1712 Operator's Manual download pdf (Page 151)

How to activate and de-activate the “auto-feed” function

The device has a further programming phase, meant for activating and de-activating

the “auto-feed” function. This function includes the emergency procedures previously

described.

NOTE: when the “auto-feed” function is de-activated, the monitor features

exclusively revolution counter function and hours counter function; the reverse

solenoid valve EVR is always de-energized and the EVS safety valve can be de-

energized (if “type 0” operation type is selected) or energized (if “type 1” operation

type is selected). The monitor is supplied as a standard with the “auto-feed” function

enabled; in fact, when the monitor is switched-on with engine off (RPM =0), the ref.

indicator "d" picture "A" pag. 7 is on.

Press key (-) minus for at least 3 seconds to de-activate the “auto-feed” function and

until the sequence below is displayed:

Auto-FeedReverse

RPM

Auto-FeedReverse

RPM

0.5 sec

Auto-FeedReverse

RPM

0.5 sec 0.5 sec

Once the sequence has been completed, engine RPMs are displayed but the ref.

indicator "d" picture "A" page 7 is off; to activate again the “auto-feed” function

press key (+) plus for at least 3 seconds until the sequence below is displayed:

Auto-FeedReverse

RPM

Auto-FeedReverse

RPM

Auto-FeedReverse

RPM

0.5 sec 0.5 sec 0.5 sec

Once the sequence has been completed, engine RPMs are displayed and the ref.

indicator "d" picture "A" page 7 is on.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 164 165

No comments

Carlton 1712 Operator's Manual Page 151