Carlton 1712 Operator's Manual download pdf (Page 44)

12” CHIPPER MACHINE CONTROLS

18

• The Auto-Feed Plus® monitors the

engine RPM and controls the feed

system based on this information. The

Auto-Feed is calibrated when installed in

the chipper with a high and low RPM

setting for the feed wheels to operate.

When the engine RPM is low and the

Auto-Feed is on, the hydraulics will not

work. If large diameter wood is being

chipped and the engine RPM drops

below the Auto-Feed Low setting, the

Auto-Feed will stop the feed wheels.

After the engine RPM is high enough to

handle the force required to chip this

material without causing the engine to

lug down, the Auto-Feed restarts the

feed wheels.

• The Auto-Feed Plus® control is

calibrated to automatically come on

when the chipper is started. If you need

to turn on the Auto-Feed Plus® control,

press and hold the right button down for

3 seconds and release.

• The Auto-Feed must be turned off to

operate the hydraulics at low engine

RPM or idle. When the Auto-Feed is on

the hydraulics only work when the

engine RPM is high. To operate the

hydraulic yoke lift or the feed wheels at

low engine RPM, turn off the Auto-Feed

by pressing and holding the left button

for 3 seconds and release.

• Read the Auto-Feed Plus® manual

supplied at the end of this manual if

programming is required.

• A two-position throttle is located on the

engine cowling. The lower (idle)

position is for starting the engine, low

speed engine operation during warm up,

clutch engagement/disengagement, and

engine cool down. The upper position is

for running the engine at full speed

during chipping operations.

AUTO-FEED OFF

AUTO-FEED ON

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 164 165

Comments to this Manuals

No comments