18” CHIPPER SERVICE
BELTS
83
• Replace belt guard cover and end guard.
Replace bolts with washers and
retighten.
• ALWAYS REMEMBER TO REPLACE
BELT GUARDS BEFORE STARTING
MACHINE. ROTATING BELTS AND
SHEAVES ARE DANGEROUS AND
COULD SEVERELY INJURE
SOMEONE.
REPLACING SHEAVE OR BUSHING
• If it becomes necessary to replace a
sheave or bushing, replace only one at a
time. Never remove both sheaves at the
same time.
• This section covers removing and
replacing the cutter disk sheave and
bushing. Follow the same procedure for
removing the engine sheave and
bushing.
• Remove belt guard bolts and remove
guard.
• Mark position of bushing on shaft before
removing for lining up bushing when
replaced.
• Remove belts as described in Replacing
Belts section.
• Remove bolts from the bushing and
screw each bolt into the threaded holes
to push sheave off bushing. Screw bolts
in equally to prevent damaging the
bushing or the sheave especially if you
plan to use either one again.
MARK BUSHING
LOCATION ON SHAFT
BEFORE REMOVING
Comments to this Manuals