18” CHIPPER SERVICE
CUTTER SYSTEM
73
SHARPEN KNIVES
• Have knives ground by a qualified
grinder.
• Grind knives at 29° to 31°.
• Before and after grinding the knife-edge,
check the width of the knife from the
center of the hole to the sharp edge of
the knife. Never use a knife with this
measurement below 2”.
• Three factors for a good cutting
system are:
1. Never use a knife with the
distance from the cutting edge
to the center of the bolt hole
less than 2”.
2. Always use knives in sets of
four with the dimension from
the cutting edge to the center of
the bolt hole as close as
possible to each other.
3. Never use a knife if the back
edge is inside the knife pocket
edge.
KNIVES
PART NO DESCRIPTION QTY
0900117 Knife – 1/2” x 4 1/2” x 7 1/4” 4
0900113A Knife – 1/2” x 4 1/2” x 5 1/4” 2
0900130
5/8” Knife Bolt – Special Design – Purchase from
JP Carlton or Dealer
16
0900129
5/8” Security Lock Nuts – Purchase from JP
Carlton or Dealer
16
Comments to this Manuals